Deck 32: Lighting and Wiring Fundamentals

Question 1

11)All of the following statements are true EXCEPT:

A) a typical wiper motor has either two or three speeds.
B) a typical permanent magnet motor has three brushes, one of which is a common ground.
C) intermittent wipers allow the driver to vary the time interval a wiper sweeps across the windshield during foggy or misty conditions.
D) electromagnet wiper motors have four brushes on the armature.

Answer 1

D

Question 2

19)Raising the turn signal mounted dimmer lever activates the high beams on most vehicles. This feature, called ____________________, works when the headlights are off as well as when the dimmer switch closes the circuit to the high beams.

Answer 2

flash to pass

Question 3

10)Which of the following is the LEAST-Likely component of the windshield wiper motor?

A) Transmission housing
B) Solenoid
C) Cam rider
D) Armature

Answer 3

B

Question 4

1)Cables are protective devices designed to melt when the flow of current becomes too high for the wiring or loads in the circuit.

Question 5

13)Which of the following statements is LEAST-Likely true?

A) Most horns operate when a diaphragm is vibrated several times a second by an electromagnet.
B) Most vehicles have two horns wired in parallel to each other and in series with the switch.
C) Pressing on the horn button closes a circuit to activate the horn capacitor.
D) The horn switch in the steering wheel is either a single or a multiple button-type switch.

Question 6

4)A type II headlamp has high beam only, with two lugs on its electrical connector.

Question 7

16)Circuit protection devices include fuses, circuit breakers, and ____________________.

Question 8

8)All of the following statements are true EXCEPT:

A) in fiber optics, light can be transmitted through a special plastic called polymethacrylate.
B) in some vehicles, fiber-optic strands illuminate an indicator on top of a fender when a turn signal flashes.
C) imported cars and some later-model domestics often use five bulbs for the brakes, turn signals, and running lights.
D) light-emitting diode (LED) lights or neon lights are sometimes used for headlights, brake lights, turn signals, and taillights.

Question 9

7)____ are activated by a mechanical switch on the brake pedal.

A) Reflectors
B) Tail lights
C) Terminals
D) Brake lights

Question 10

9)While having a discussion, Technician A says that an adaptive brake light system on some vehicles causes the size and intensity of the stop lights to increase in response to a driver pushing harder on the brake pedal or during an antilock brake stop. Technician B says that during a normal stop, the brake lights and center high-mount brake lamp illuminate normally. Who is correct?

A) A only
B) B only
C) Both A and B
D) Neither A nor B

Question 11

14)While having a discussion, Technician A says that the horn circuit includes the horn, a fuse and wiring, the horn switch in the steering wheel, and a capacitor. Technician B says that the horn circuit includes the horn, a fuse and wiring, the horn switch in the steering wheel, and a relay. Who is correct?

A) A only
B) B only
C) Both A and B
D) Neither A nor B

Question 12

2)Conventional incandescent light bulbs, often called lamps, have filaments that electricity flows through.

Question 13

3)Sealed-beam headlights have an inner glass or plastic reflector surface that is sprayed with an aluminum reflective material.

Question 14

5)Daytime running lights are illuminated at a lower intensity than normal headlights.

Question 15

6)Headlamp intensity is rated in ____.

A) amps
B) candlepower
C) watts
D) volts

Question 16

20)The ____________________ varies the amount of time it takes to recharge the capacitor, which triggers an electronic switch to begin wiper operation.

Question 17

17)Low-voltage wiring is called ____________________.

Question 18

12)The part that MOST-Likely allows the wiper interval to be adjusted is the:

A) rheostat
B) capacitor
C) armature
D) fuse

Question 19

18)____________________ are large wires that allow more electrical current to flow.

Question 20

15)The term MOST-Likely used to refer to today's dashboard is:

A) gauge
B) instrument panel
C) regulator
D) armature

Question 21

25)List six warning lights in vehicle electric systems.

Question 22

21)What is the difference between a type I headlamp and a type II headlamp?

Question 23

24)What is the purpose of an electric engine coolant temperature (ECT) sensor?

Question 24

23)What is CHMSL and what does it consist of?

Question 25

22)Why does a neon light last longer than an ordinary light?