Deck 7: Pipe Fit-Up and Alignment

Question 1

Most _____ give specifications on the alignment of abutting pipe ends. ​

A)codes​
B)operations​
C)qualifications​
D)alignments​

Answer 1

A

Question 2

_____ is the term given to the vertical distance at the center point of bends of two pieces of pipe that are parallel to each other. ​

A)Rise​
B)Bend​
C)Run​
D)Ratio​

Answer 2

A

Question 3

_____ is the term given to the diagonal distance at the center point of bends of two pipes that are running parallel to each other. ​

Answer 3

Travel

Question 4

What should you do when there is a need to use an elbow that is not the standard 45 or 90 degrees? ​

Question 5

In most cases, a ratio is expressed as a _____. ​

Question 6

What is counterboring??

Question 7

Why are pipe jack stands useful for a welder to have? ​

Question 8

_____ is where the internal surface of the material does not line up. ​

A)High-low​
B)Low-high​
C)Weld line​
D)Line weld​

Question 9

What are external reforming rim clamps designed for? ​

Question 10

Alignment pins are used to make sure that _____ are positioned so that bolt holes are in alignment for bolting. ​

A)offsets​
B)bends​
C)flanges​
D)saddles​

Question 11

A _____ is the length of the legs of a triangle divided by one another. ​

A)ration​
B)rise​
C)bend​
D)run​

Question 12

_____, scribes, and paint markers are used to mark materials for cutting and fitting. ​

Question 13

_____ is a process whereby the edges of a pipe are cut mechanically so that the ends are square. ​

A)Scope​
B)Rise​
C)Facing​
D)Run​

Question 14

Pipe bends, turns, and changes in direction or elevation are referred to as _____. ​

A)saddles​
B)flanges​
C)bends​
D)offsets​

Question 15

_____ is the mathematical study of the sides and angles of triangles. ​

A)Geometry​
B)Calculus​
C)Algebra​
D)Trigonometry​

Question 16

The _____ defines the type of edge preparation that will be required on a pipe. ​

A)WPS​
B)API​
C)ID​
D)ASME​

Question 17

Using _____ can help make the layout process faster and more productive. ​

Question 18

What is the goal of specifications on the alignment of abutting pipe ends? ​

Question 19

If any two legs of a right triangle are known, the other leg can be determined by utilizing the _____ theorem. ​

Question 20

_____ tools consist of tools that clamp and hold pipe for welding. ​

A)Pinning​
B)Cutting​
C)Fitting​
D)Alignment​