Deck 8: One-View Drawings

Question 1

For a gasket or shim, which of the following would most likely be specified by a note?

A)Hole radius
B)Thickness
C)Length
D)Hole spacing

Answer 1

B

Question 2

In a one view drawing, you could tell if a part is cylindrical because:

A)You can assume a part is cylindrical unless stated otherwise
B)A centerline or diameter symbol would be shown
C)Chamfers on the end of the part imply that it is round
D)You would not be able to tell, so a second view is always required

Answer 2

B

Question 3

Which of the following parts would NOT be suitable for a one-view drawing?

A)A rod
B)A gasket
C)A pin
D)A pump housing

Answer 3

D