Deck 22: Finishing the Exterior and Interior of Light Wood Frame Buildings

Question 1

A(n) ____ forms when the melted snow refreezes as it runs to an uninsulated eave.

A) snow melt
B) ice dam
C) air leak
D) ridge dam

Answer 1

B

Question 2

What are eaves and rakes designed to do?

Answer 2

Eaves and rakes are designed to protect walls from excessive wear, provide shade, and complement the architectural style of the
building . The eaves are the part of the roof edge that runs parallel with the roof ridge. The rake of a roof is perpendicular to the ridge and eaves.

Question 3

When are gutters installed and what are their basic properties and purpose?

Answer 3

After shingles are in place gutters may be installed, although this is often delayed until the exterior is finished to keep them from being damaged. Gutters are commonly made from either aluminum or vinyl. The finished roofing material extends about 3/4 in. over the edge of the fascia and directs water into the gutter. The gutter also serves as a decorative finish on the fascia.

Question 4

____ exterior surfaces may be constructed using a finish coat of a Portland cement, lime, and sand mixture.

A) Glass-fiber
B) Vinyl
C) Stucco
D) Aluminum

Question 5

The finished board covering the ends of the rafters is called the ____.

A) fascia
B) soffit
C) eve
D) rake

Question 6

What are the commonly known names of house wrap and what is its purpose?

Question 7

What is interior finish carpentry sometimes referred to and what does it involve?

Question 8

____ are the moldings used to trim around doors, windows, and other openings and are available in a wide range of sizes and patterns.

A) Casings
B) Baseboards
C) Gypsums
D) Copings

Question 9

Explain how brick and stone veneers are put in place as exterior siding.

Question 10

____ should fit snugly against top and bottom plates and are cut to fit tightly around plumbing and electrical boxes.

A) Fascias
B) Soffits
C) Batts
D) Blankets