Deck 12: Fillet Welds

Question 1

When the ____ symbol is used, a length dimension is not needed.

A) weld-all-around
B) weld-around
C) weld-full
D) weld-completely

Answer 1

A

Question 2

The ____ weld is one of the most widely used types of welds.

A) fillet
B) fill
C) filling
D) filled

Answer 2

A

Question 3

The fillet weld symbol is always drawn so that the ____________________ leg is to the reader's left.

Answer 3

vertical

Question 4

Intermittent welding consists of a series of ____ welds.

A) long
B) long-short-long
C) short-long
D) short

Question 5

In a fillet weld symbol, the two legs are assumed to be equal in size unless otherwise specified.

Question 6

____ lines are used as terminal points for the section lining.

A) Reference
B) Dimension
C) Extension
D) Extended

Question 7

Only the fillet weld symbol may be used in combination with other symbols.

Question 8

Each short weld in intermittent welding is called a(n) ____.

A) increment
B) increase
C) step
D) change

Question 9

Specific lengths of fillet welds can be described by placing the symbols in conjunction with the ____ lines of the drawing.

A) reference
B) dimension
C) weld
D) control

Question 10

When a length is not specified on the welding symbol, the fillet weld is assumed to be ____________________.

Question 11

If the fillet weld symbol has unequal legs, the size of each leg is indicated in ____ at the left of the weld symbol.

A) braces
B) brackets
C) dashes
D) parentheses

Question 12

Extension and ____ lines are occasionally used with the welding symbol to locate the desired welds.

A) reference
B) dimension
C) dashed
D) referring

Question 13

If the length of the weld is specified, it is placed on the immediate left of the weld symbol.

Question 14

____________________ intermittent welding means that the welds appear directly opposite each other on the two sides of the joint.

Question 15

Fillet welds must always have equal legs.

Question 16

The size of a fillet weld refers to the length of the ____ of the weld.

A) arms
B) sides
C) legs
D) stretchers

Question 17

If a fillet is shown on both sides of the joint, it is identified as a(n) ____________________ fillet weld.

Question 18

When a general note covers the size of fillet welds, the dimension does not usually appear on the welding symbol.

Question 19

The center-to-center distance, in inches or millimeters of each increment, is the ____.

A) angle
B) step
C) groove
D) pitch

Question 20

A(n) ____________________ represents length of weld.