Deck 3: Stationary Power Tools

Question 1

The common table saw found on the job is the __.

A) 8 inch model
B) 10 inch model
C) 12 inch model
D) 14 inch model

Answer 1

B

Question 2

Small turning radii while using a band saw requires the use of 3/4" bands.

Answer 2

False

Question 3

When ripping a narrow strip a(n) __ is used to safely finish the cut.

A) push stick
B) miter gauge
C) rip fence
D) anti-kick back device

Answer 3

A

Question 4

Sliding compound miter saws come in sizes ranging __.

A) 6 1/2 to 7 1/4 inch
B) 6 1/2 to 10 inch
C) 7 1/4 to 12 inch
D) 8 1/2 to 12 inch

Question 5

A jointer is used to smooth stock surfaces to remove the marks made by sawing.

Question 6

Dado blades are used to cut material with small kerfs.

Question 7

Shapers are used to prepare rough material with ripping and cross cutting operations.

Question 8

It is often safe when operating a table saw to use the rip fence and miter gauge at the same time.

Question 9

The size of a table saw is determined by the ____ of the saw blade.

A) diameter
B) metal
C) teeth
D) kerf

Question 10

A ____ is a precision drilling tool consisting of a base, column, table, and head.

A) shaper
B) molder
C) filer
D) drill press

Question 11

It is often not necessary to disconnect the power cord when adjusting the fences on a stationary power tool.

Question 12

____ sanders in the form of a drum, disk, and belt are designed to smooth most any shaped piece of work.

A) Bench
B) Transitional
C) Oscillating spindle
D) Combination

Question 13

The band saw cuts with a revolving strip of metal that has teeth.

Question 14

The jointer outfeed table is __.

A) adjustable
B) set to the height of the cutters
C) totally covered by the safety shield
D) all of the above

Question 15

When operating a table saw, proper feed rate is determined by listening to the blade speed.

Question 16

Sliding compound miter saws can only cut miters.

Question 17

Fences may be used on __.

A) table saws
B) band saws
C) jointers
D) all of the above

Question 18

The table saw tool best suited for cross cutting is the rip fence.

Question 19

A ____ is constructed with two tables: infeed and outfeed.

A) plane
B) sander
C) jointer
D) finisher

Question 20

The ____ saw is a tool designed to cut irregular shapes in various thicknesses of material.

A) miter
B) band
C) dado
D) crosscut

Question 21

A tool designed to make accurate repetitive holes in material is called __________.

Question 22

The cutting operation that cuts wood with the grain is called __________.

Question 23

A band saw band is held in proper position by __________.

Question 24

A saw blade designed to made wide cuts in wood is called a __________.

Question 25

Miter saws typically can be adjusted left or right to an angle of __________.

Question 26

A good safety habit is to adjust the table saw blade to about __________. above the stock.

Question 27

When using a jointer it is best to avoid placing fingers __________.

Question 28

The adjustable part of a jointer that determines the depth of cut is called the __________.

Question 29

The term used to describe cutting boards into thinner pieces is called __________.

Question 30

Safety shield of a jointer protects the operator from the __________.