Deck 12: Completing a Floor Plan With Cad

Question 1

An important key to remember on multilevel homes is to never move one floor level without moving all levels.

Answer 1

True

Question 2

What sheet number should be assigned to the main floor plan?

A) A1
B) A10
C) A100
D) A1.0

Answer 2

C

Question 3

If the home is being designed for universal appeal, all doors on an access route must have a minimum of ____ of clearance.

A) 24" (600 mm)
B) 32" (815 mm)
C) 48" (1200 mm)
D) 60" (1500 mm)

Answer 3

B

Question 4

Residential floor plans are usually plotted at a scale of 1'' = 1'-0''.

Question 5

When placing symbols on the floor plan, you should represent the kitchen plumbing fixtures, such as the main work sink, vegetable sink or party sink, on the ____ layer.

A) FLOR STRS
B) FLOR APPL
C) FLOR PLMB
D) FLOR DECK

Question 6

To keep drawings stacked, you should thaw all layers after moving one layer.

Question 7

Cabinets should be drawn using which two commands?

A) ARRAY and COPY
B) TRIM and MIRROR
C) MIRROR and ARRAY
D) OFFSET and PROPERTIES

Question 8

You should allow for a minimum of ____ at the interior edge of windows near a corner of bay windows.

A) 2'' (50 mm)
B) 3'' (75 mm)
C) 6'' (150 mm)
D) 12'' (300 mm)

Question 9

As a base drawing, the floor plan can be saved and related information can be attached using the ____ command.

A) OFFSET
B) FILLET
C) XREF
D) INSERT

Question 10

When placing symbols on the floor plan, you should represent changes in floor levels, such as lowered floors, on which layer?

A) FLOR STRS
B) FLOR APPL
C) FLOR OVHD
D) FLOR DECK

Question 11

A wall 16'-2'' will require ____ sheets of OSB, with 3'-10'' left over.

A) two
B) three
C) four
D) five

Question 12

To start drawing a second floor, you should create the needed layers and then _____ the main floor information.

A) freeze
B) thaw
C) delete
D) replace

Question 13

Even if you are drawing plans for a construction site where seismic risk is high, you can alter window placement depending on whether an engineer supervises the design or the design follows the prescriptive path of the IRC.

Question 14

Depending on the complexity of the project, dimensions may be placed on the floor plan or framing plan, but not on both.

Question 15

A minimum of ____ is usually placed between window openings.

A) 2'' (50 mm)
B) 3'' (75 mm)
C) 6'' (150 mm)
D) 12'' (300 mm)