Deck 14: Fundamentals of Metal Forming

Question 1

Stresses applied in most metal forming operations are which one of the following:

A)compressive
B)shear
C)tensile

Answer 1

compressive

Question 2

Which of the following are desirable properties of the work material in metal forming (two best answers):

A)high ductility
B)high tensile strength
C)high yield strength
D)low ductility
E)low tensile strength
F)low yield strength

Answer 2

high ductility
low yield strength

Question 3

Which of the following are bulk deformation processes (three correct answers):

A)bending
B)deep drawing
C)extrusion
D)forging
E)rolling
F)shearing

Answer 3

extrusion
forging
rolling

Question 4

Which of the following is typical of the starting work geometry in sheet metal processes:

A)high volume to area ratio
B)low volume to area ratio

Question 5

The flow curve expresses the behavior of a metal in which of the following regions of the stress-strain curve:

A)elastic region
B)plastic region

Question 6

The average flow stress is the flow stress multiplied by which of the following factors:

A)n
B)(1+n)
C)1/n
D)1/(1+n) where n is the strain-hardening exponent

Question 7

Hot working of metals refers to which one of the following temperature regions relative to the melting point of the given metal:

A)room temperature
B)0.2T_m
C)0.4T_m
D)0.6T_m where T_m = the melting temperature on an absolute temperature scale

Question 8

Which of the following are advantages and characteristics of hot working relative to cold working (four correct answers):

A)fracture of workpart is less likely
B)friction is reduced
C)increased strength properties
D)isotropic mechanical properties
E)less overall energy is required
F)lower deformation forces are required
G)more significant shape changes are possible
H)strain-rate sensitivity is reduced

Question 9

Increasing strain rate tends to have which one of the following effects on flow stress during hot forming of metal:

A)decreases flow stress
B)has no effect
C)increases flow stress

Question 10

The coefficient of friction between the part and the tool in cold working tends to be

A)higher
B)lower
C)no different relative to its value in hot working