Deck 12: Fillet Welds

Question 1

The ____ weld is one of the most widely used types of welds.

A) fillet
B) fill
C) filling
D) filled

Answer 1

A

Question 2

When a length is not specified on the welding symbol, the fillet weld is assumed to be ____________________.

Answer 2

continuous

Question 3

If the length of the weld is specified, it is placed on the immediate left of the weld symbol.

Answer 3

False

Question 4

The fillet wield symbol is always drawn so that the ____________________ leg is to the reader's left.

Question 5

If the fillet weld symbol has unequal legs, the size of each leg is indicated in ____ at the left of the weld symbol.

A) braces
B) brackets
C) dashes
D) parentheses

Question 6

The size of a fillet weld refers to the length of the ____ of the weld.

A) arms
B) sides
C) legs
D) stretchers

Question 7

____ lines are used as terminal points for the section lining.

A) Reference
B) Dimension
C) Extension
D) Extended

Question 8

____________________ intermittent welding means that the welds appear directly opposite each other on the two sides of the joint.

Question 9

When a general note covers the size of fillet welds, the dimension does not usually appear on the welding symbol.

Question 10

Only the fillet weld symbol may be used in combination with other symbols.

Question 11

The center-to-center distance, in inches or millimeters of each increment, is the ____.

A) angle
B) step
C) groove
D) pitch

Question 12

Fillet welds must always have equal legs.

Question 13

Specific lengths of fillet welds can be described by placing the symbols in conjunction with the ____ lines of the drawing.

A) reference
B) dimension
C) weld
D) control

Question 14

Intermittent welding consists of a series of ____ welds.

A) long
B) long-short-long
C) short-long
D) short

Question 15

In a fillet weld symbol, the two legs are assumed to be equal in size unless otherwise specified.

Question 16

Extension and ____ lines are occasionally used with the welding symbol to locate the desired welds.

A) reference
B) dimension
C) dashed
D) referring

Question 17

When the ____ symbol is used, a length dimension is not needed.

A) weld-all-around
B) weld-around
C) weld-full
D) weld-completely

Question 18

If a fillet is shown on both sides of the joint, it is identified as a(n) ____________________ fillet weld.

Question 19

A(n) ____________________ represents length of weld.

Question 20

Each short weld in intermittent welding is called a(n) ____.

A) increment
B) increase
C) step
D) change