Deck 7: Production Economics

Question 1

In a relationship among total,average and marginal products,where TP is maximized:

A) AP is maximized
B) AP is equal to zero
C) MP is maximized
D) MP is equal to zero
E) none of the above

Answer 1

D

Question 2

The marginal product is the incremental change in total output that can be obtained from the use of one more unit of an input in the production process,while holding constant all other inputs.
​

Answer 2

True

Question 3

Marginal revenue product is defined as the amount that an additional unit of the variable input adds to ____.

A) marginal revenue
B) total output
C) total revenue
D) marginal product
E) none of the above

Answer 3

C

Question 4

In a production process,an excessive amount of the variable input relative to the fixed input is being used to produce the desired output.This statement is true for:

A) stage II
B) stages I and II
C) when Ep = 1
D) stage III
E) none of the above

Question 5

In production and cost analysis,the short run is the period of time in which one (or more)of the resources employed in the production process is fixed or incapable of being varied.

Question 6

Suppose you have a Cobb-Douglas function with a capital elasticity of output (á)of 0.28 and a labor elasticity of output (â)of 0.84.What statement is correct?

A) There are increasing returns to scale
B) If the amount of labor input (L)is increased by 1%,the output will increase by 0.84%
C) If the amount of capital input (K)is decreased by 1%,the output will decrease by 0.28%
D) The sum of the exponents in the Cobb-Douglas function is 1.12.
E) All of the above

Question 7

If the marginal product of labor is 100 and the price of labor is 10,while the marginal product of capital is 200 and the price of capital is $30,then what should the firm?

A) The firm should use relatively more capital
B) The firm should use relatively more labor
C) The firm should not make any changes - they are currently efficient
D) Using the Equimarginal Criterion,we can't determine the firm's efficiency level
E) Both c and d

Question 8

The Cobb-Douglas production function is: Q = 1.4*L^0.6*K^0.5.What would be the percentage change in output (%?Q)if labor grows by 3.0% and capital is cut by 5.0%?

A) %?Q = + 3.0%
B) %?Q = + 5.0%
C) %?Q = - 0.70%
D) %?Q = - 2.50%
E) %?Q = - 5.0%

Question 9

Holding the total output constant,the rate at which one input X may be substituted for another input Y in a production process is:

A) the slope of the isoquant curve
B) the marginal rate of technical substitution (MRTS)
C) equal to MP_x/MP_y
D) all of the above
E) none of the above

Question 10

Which of the following is never negative?

A) marginal product
B) average product
C) production elasticity
D) marginal rate of technical substitution
E) slope of the isocost lines

Question 11

Concerning the maximization of output subject to a cost constraint,which of the following statements (if any)are true?

A) At the optimal input combination,the slope of the isoquant must equal the slope of the isocost line.
B) The optimal solution occurs at the boundary of the feasible region of input combinations.
C) The optimal solution occurs at the point where the isoquant is tangent to the isocost lines.
D) all of the above
E) none of the above

Question 12

The combinations of inputs costing a constant C dollars is called:

A) an isocost line
B) an isoquant curve
C) the MRTS
D) an isorevenue line
E) none of the above

Question 13

The marginal product is the incremental change in total output that can be obtained from the use of one more unit of an input in the production process,while varying all other inputs.

Question 14

The marginal rate of technical substitution may be defined as all of the following except:

A) the rate at which one input may be substituted for another input in the production process,while total output remains constant
B) equal to the negative slope of the isoquant at any point on the isoquant
C) the rate at which all combinations of inputs have equal total costs
D) equal to the ratio of the marginal products of X and Y
E) b and c

Question 15

The isoquants for inputs that are perfect substitutes for one another consist of a series of:

A) right angles
B) parallel lines
C) concentric circles
D) right triangles
E) none of the above

Question 16

The law of diminishing marginal returns:

A) states that each and every increase in the amount of the variable factor employed in the production process will yield diminishing marginal returns
B) is a mathematical theorem that can be logically proved or disproved
C) is the rate at which one input may be substituted for another input in the production process
D) none of the above

Question 17

The marginal product is defined as:

A) The ratio of total output to the amount of the variable input used in producing the output
B) The incremental change in total output that can be produced by the use of one more unit of the variable input in the production process
C) The percentage change in output resulting from a given percentage change in the amount
D) The amount of fixed cost involved.
E) None of the above

Question 18

What's true about both the short-run and long-run in terms of production and cost analysis?

A) In the short-run,one or more of the resources are fixed
B) In the long-run,all the factors are variable
C) The time horizon determines whether or not an input variable is fixed or not
D) The law of diminishing returns is based in part on some factors of production being fixed,as they are in the short run.
E) All of the above

Question 19

The following is a Cobb-Douglas production function: Q = 1.75K^0.5·L^0.5.What is correct here?

A) A one-percent change in L will cause Q to change by one percent
B) A one-percent change in K will cause Q to change by two percent
C) This production function displays increasing returns to scale
D) This production function displays constant returns to scale
E) This production function displays decreasing returns to scale

Question 20

Marginal revenue product is:

A) defined as the amount that an additional unit of the variable input adds to the total revenue
B) equal to the marginal factor cost of the variable factor times the marginal revenue resulting from the increase in output obtained
C) equal to the marginal product of the variable factor times the marginal product resulting from the increase in output obtained
D) a and b
E) a and c

Question 21

Given a Cobb-Douglas production function estimate of Q = 1.19L^.72K^.18 for a given industry,this industry would have:

A) increasing returns to scale
B) constant returns to scale
C) decreasing returns to scale
D) negative returns to scale
E) none of the above

Question 22

The Cobb-Douglas production function has which of the following properties?

A) output is a linear increasing function of each of the inputs
B) it provides a good fit to the traditional S-shaped production function
C) the elasticity of production is constant and equal to 1 minus the exponent of the appropriate variable
D) all of the above
E) none of the above

Question 23

Emco Company has an assembly line of fixed size A.Total output is a function of the number of workers (crew size)as shown in the following schedule: $\begin{array}{cc}\begin{array}{c}\text { Crew Size } \\\text { (No. of Workers) }\end{array} & \begin{array}{c}\text { Total Output } \\\text { (No. of Units) }\end{array} \\\hline 0 & 0 \\1 & 10 \\2 & 35 \\3 & 50 \\4 & 56 \\5 & 59 \\6 & 60 \\7 & 60 \\8 & 58\end{array}$ Determine the following schedules: (a) marginal productivity of labor
(b) average productivity of labor
(c) elasticity of production with respect to labor

Question 24

The isoquants for inputs that are perfect complements for one another consist of a series of:

A) right angles
B) parallel lines
C) concentric circles
D) right triangles
E) none of the above

Question 25

The original Cobb-Douglas function was given as $\mathrm { Q } = \alpha \mathrm { L } ^ { \rho } \mathrm { L } ^ { 1 - \rho }$ .It was subsequently rewritten as $\mathrm { Q } = \alpha \mathrm { L } ^ { \rho 1 } \mathrm {~K} ^ { \rho2}$ .What benefit was derived in the revision?

A) the function becomes a non-linear relationship so it would fit to production curves having an "S" shape
B) returns to scale can be shown in the revision
C) returns to scale become constant
D) a and b only
E) a,b,and c

Question 26

Marginal factor cost is defined as the amount that an additional unit of the variable input adds to ____.

A) marginal cost
B) variable cost
C) marginal rate of technical substitution
D) total cost
E) none of the above

Question 27

In the Cobb-Douglas production function ( $\mathrm { Q } = \alpha \mathrm { L } ^ { \rho 1 } \mathrm {~K} ^ { \rho 2 }$ ):

A) the marginal product of labor (L)is equal to ?1
B) the average product of labor (L)is equal to ?2
C) if the amount of labor input (L)is increased by 1 percent,the output will increase by ?1 percent
D) a and b
E) a and c

Question 28

An industry can be characterized by the following production function:
Q = 2.5L^.60 C^.40 (a) What is the algebraic expression for the marginal productivity oflabor?
(b) What is the algebraic expression for the average productivity of labor?
(c) How would you characterize the returns-to-scale in the industry?

Question 29

The primary purpose of the Cobb-Douglas power function is to:

A) allow one to make estimates of cost-output relationships
B) allow one to make predictions about a resulting increase in output for a given increase in the inputs
C) aid one in gaining accurate empirical values for economic variables
D) calculate a short-run linear total cost function
E) a and b