Deck 7: Introduction to Router Configuration

Question 1

The designation s0/0 indicates which of the following?

A)Serial interface zero/zero
B)Ethernet serial interface zero
C)Serial input zero
D)Is not used with Cisco routers

Answer 1

A

Question 2

AUI stands for which of the following?

A)Auxiliary unit interface
B)Attachment unit interconnect
C)Auxiliary unity interconnect
D)Attachment unit interface
E)None of these answers are correct.

Answer 2

D

Question 3

The router commands used to configure and enable the FastEthernet 0/1 router interface with the IP address of 10.10.20.250 and a subnet mask of 255.255.0.0 are:
Router# conf t
Router(config)# int fa0/1
Router(config-if)# ip address 10.10.20.250 255.255.0.0
Router(config-if)# no shut
True or False?

Answer 3

True

Question 4

The command line vty 0 4 means:
line places the router in the line configuration mode
vty: virtual terminal
0 4: indicates virtual terminal connections can be simultaneously configured
True or False?

Question 5

The values for configuring a serial connection to connect to a Cisco router's console port are:
5600bps
8 data bits
No parity
1 stop bit
Hardware flow control
True or False?

Question 6

The sequence of commands for setting the enable secret to Chile is:
router> enable
router# enable secret Chile
True or False?

Question 7

The DCE end of a V.35 cable is female.True or False?

Question 8

The AUI port on a router connects to which networking protocol?

A)100BaseT
B)Token-Ring
C)Ethernet
D)CAT5e
E)None of these answers are correct.

Question 9

The prompt for a router's user EXEC mode is router/ >.True or False?

Question 10

The sh ip int brief command shows that the protocol for Ethernet0 is "down" and the status is up.This indicates which of the following?

A)The router interface is not enabled.
B)The routing protocol has not been configured.
C)The router is not communicating with another networking device.
D)None of these answers are correct.