The governor cutout pressure is around 8 psi lower than specification on a truck tested during a PMI.Which of the following adjustments would be more likely to correct the cutout pressure?
A) turn governor adjusting screw CCW 1/2 turn,then retest
B) turn governor adjusting screw CW 1/2 turn,then retest
C) turn governor adjusting screw CCW one full turn,then retest
D) turn governor adjusting screw CW one turn,then retest
Correct Answer:
Verified
Q9: What values MUST governor cutout pressure be
Q10: What angle should be formed between a
Q11: An air compressor fails to build to
Q12: What is the usual maximum cam-to-bushing radial
Q13: How often should a typical air dryer
Q15: Air continuously leaks from the exhaust port
Q16: If the air compressor does not have
Q17: If a post-2010 truck air system is
Q18: When performing a reservoir leakage test,what is
Q19: If a truck air compressor cutout pressure
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents