Solved

While Configuring the VRF Selection Feature, You Get an Error

Question 4

Multiple Choice

While configuring the VRF Selection feature, you get an error message after typing the below statement: Router(config) #no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1 Which action caused this message?


A) the entry of an inconsistent IP address and mask for VRF Selection
B) an attempt to configure a VRF instance on an interface that already has VRF Selection configured
C) an attempt to remove a VRF Selection entry that does not exist
D) an attempt to configure a VRF Selection table that does not exist

Correct Answer:

verifed

Verified

Unlock this answer now
Get Access to more Verified Answers free of charge

Related Questions

Q1: Which two are characteristics of using a

Q2: Which utility can you use to validate

Q3: You try to configure MPLS VPN VRF

Q5: While troubleshooting EoMPLS configuration problems, which three

Q6: Refer to the</p></div><svg width=

Q7: In a typical service provider environment, which

Q8: An engineer is investigating an MPLS LDP

Q9: Refer to the</p></div><svg width=

Q10: While troubleshooting an AToM L2VPN service, a

Q11: Refer to the</p></div><svg width=

Unlock this Answer For Free Now!

View this answer and more for free by performing one of the following actions

qr-code

Scan the QR code to install the App and get 2 free unlocks

upload documents

Unlock quizzes for free by uploading documents