In order to prime a typical fuel sub-system with a hand-primer pump that has to be installed into the circuit, where should it ideally be located?
A) close to the pick-up tube
B) upstream from the primary filter
C) upstream from the transfer pump
D) downstream from the secondary filter
Correct Answer:
Verified
Q22: What is a fuel water separator unable
Q23: When comparing the properties of diesel fuel
Q24: What two principles are used by most
Q25: What pumping principle is used on transfer
Q26: What pumping principle is used by hand-actuated
Q28: What can result from a water-in-fuel condition
Q29: What should be used to diagnose an
Q30: When a fuel heater is used in
Q31: What device is used to sense the
Q32: What is the currently recommended method of
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents