The primary detector in a pressure gauge is usually
A) Bellows
B) Diaphragm
C) Spring
D) Bourdon tube
E) Coil spring
Correct Answer:
Verified
Q26: Hardness tester used for determining the hardness
Q27: In gang milling
A)Work is fed into the
Q28: A gagger is
A)A tool used in clearing
Q29: Which of the following is gear finishing
Q30: Abrasive GC indicates
A)White Al2O3
B)Parting off
C)Al2O3
D)Green grit SiC
E)SiC
Q32: Which type of gears can be manufactured
Q33: Chip breaker is
A)an obstruction attached to face
Q34: Point angle of 135° to 150° is
Q35: Back rake angle while turning brass is
A)5°
B)10°
C)Parting
Q36: The cutting tool is
A)Goose neck tool
B)Parting tool
C)Threading
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents