Technician A says that the outer portion of the driveshaft can be used as a slide hammer to pop the inboard CV joint out of the transaxle. Technician B says that you should not hammer on the outer end of the outboard CV joint to get it out of the hub. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians A and B
D) Neither technician A nor B
Correct Answer:
Verified
Q16: Which tool is used to measure U-Joint
Q17: The most common complaint from CV joint
Q18: A clunk noise from the drive line
Q19: Technician A hammers on a tie rod
Q20: Two technicians are discussing FWD driveshaft service.
Q22: Most outboard CV joints are held onto
Q23: FWD driveshaft problems are usually indicated by
Q24: Technician A says that CV joint grease
Q25: Technician A says that a proper U-joint
Q26: Which is not part of the diagnostic
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents