تكلم مع الذكاء الاصطناعي
Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
النسخة 8الرقم المعياري الدولي: 978-0134156323Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
النسخة 8الرقم المعياري الدولي: 978-0134156323 تمرين 2
In problem 16.1, if the tolerance changes to 
0.0004 inch, approximately what percentage of the shafts will be within tolerance?
(Reference Problem 16.1)
The specification for the length of a shaft is 12 inches
0.001 inch. If the process standard deviation is 0.00033, approximately what percentage of the shafts will be within tolerance?
0.0004 inch, approximately what percentage of the shafts will be within tolerance?(Reference Problem 16.1)
The specification for the length of a shaft is 12 inches
0.001 inch. If the process standard deviation is 0.00033, approximately what percentage of the shafts will be within tolerance?التوضيح
موثّق
موثّق
Tolerances basically refer to the bounda...
Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
لماذا لم يعجبك هذا التمرين؟
أخرى 8 أحرف كحد أدنى و 255 حرفاً كحد أقصى
حرف 255
