Deck 7: Compactlogix I-O Configuration

Question 1

In the Fault/Program Action screen, Connection mode is defined as when the controller goes into Program mode or Remote Test mode, or experiences a major recoverable fault or a communications failure.

Answer 1

False

Question 2

When configuring an analog output module and Use Fault Value is selected, the value entered in this parameter will be output.

Answer 2

True

Question 3

The Program Mode setting for each output point can be set to On, Off, or Hold. How does each setting work when the controller goes into Program mode?

Answer 3

When the controller goes into Program mode:
• On means this output point will be turned on if it is not already on.
• Off means this output point will be turned off if it is not already off.
• Hold leaves the output point in its current state

Question 4

The module name is not part of the I/O points tags associated with the module's input points.

Question 5

When entering settings on the Fault/Program screen for a new module, Fault mode is defined as when the controller experiences a major nonrecoverable fault.

Question 6

Briefly describe why problems are likely to occur if a module with a higher version and keying is disabled.

Question 7

The CompactLogix members of the ControlLogix family include the 1768 and the 1769 CompactLogix platforms. Both platforms use the same ____________________ modules.

Question 8

Inhibit Module should not be checked during startups and debugging.

Question 9

When a new I/O module is added to an existing RSLogix 5000 project, the module must be ____________________ before its I/O tags are available for programming.

Question 10

If communications with the controller fail, outputs from the controller are ignored, and the selected Fault mode is used. The Fault mode default setting is ____________________.

Question 11

Which personnel are typically responsible for the manual process of I/O configuration in ControlLogix systems?

Question 12

The electronic keying setting that is typically used by project developers in the early stages of a project when the specific modules have not been installed is ____________________.

Question 13

Briefly describe the Compatible Module selection for electronic keying.

Question 14

When selecting a module to configure, what are the three tab selections available in the Select Module window?

Question 15

If the module is faulted, a hexadecimal error code and explanation displays in the Module Fault box. Additional information can be found by clicking the ____________________ button.