Deck 48: Volvo and Mack Engine Management

Question 1

What is the current Mack Trucks online service information system known as?

A) Electrical information system (EIS)
B) IMPACT
C) V-MAC
D) Co-Pilot

Answer 1

Electrical information system (EIS)

Question 2

What is the current Volvo engine diagnostic software known as?

A) IMPACT
B) TechTool (TT)
C) Premium Tech Tool (PTT)
D) EIS

Answer 2

TechTool (TT)

Question 3

Technician A says that Mack V-MAC IV and Volvo VECTRO III are essentially the same management system. Technician B says that V-MAC III and VECTRO III both manage pre-2007 single actuator EUI systems. Who is right?

A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Answer 3

Technician A only

Question 4

What is the current Mack Trucks diagnostic software known as?

A) IMPACT
B) TechTool (TT)
C) Premium Tech Tool (PTT)
D) EIS

Question 5

What is the Volvo service information system known as?

A) IMPACT
B) TT
C) PTT
D) EIS

Question 6

What term (acronym) do both Mack Trucks and Volvo use to describe their current engine controller module?

A) ECU
B) EECU
C) VCU
D) PLD

Question 7

Which of the following is required to reprogram a Volvo or Mack twin-actuator EUI calibration code?

A) single digit alpha code
B) two-digit numeric code
C) four-digit numeric code
D) six-digit numeric code

Question 8

What is the displacement of a Mack Trucks MP8 engine?

A) 8 liters
B) 11 liters
C) 13 liters
D) 16 liters

Question 9

What was the Volvo diagnostic software for pre-2007 engines known as?

A) VCADS
B) VECTRO
C) V-MAC
D) DOS

Question 10

Technician A says that Mack Trucks driver information display (DID) can be used to read active engine fault codes. Technician B says that DID can be used to inhibit a DPF regeneration event. Who is correct?

A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B