Chat with AI
Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
Edition 8ISBN: 978-0134156323Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
Edition 8ISBN: 978-0134156323 Exercise 2
In problem 16.1, if the tolerance changes to 
0.0004 inch, approximately what percentage of the shafts will be within tolerance?
(Reference Problem 16.1)
The specification for the length of a shaft is 12 inches
0.001 inch. If the process standard deviation is 0.00033, approximately what percentage of the shafts will be within tolerance?
0.0004 inch, approximately what percentage of the shafts will be within tolerance?(Reference Problem 16.1)
The specification for the length of a shaft is 12 inches
0.001 inch. If the process standard deviation is 0.00033, approximately what percentage of the shafts will be within tolerance?Explanation
Verified
Verified
Tolerances basically refer to the bounda...
Introduction to Materials Management 8th Edition by Steve Chapman ,Tony Arnold ,Ann Gatewood ,Lloyd Clive
Why don’t you like this exercise?
Other Minimum 8 character and maximum 255 character
Character 255
