Deck 3: Stationary Power Tools

Question 1

Shapers are used to prepare rough material with ripping and cross cutting operations.

Answer 1

False

Question 2

The size of a table saw is determined by the ____ of the saw blade.

A)diameter
B)metal
C)teeth
D)kerf

Answer 2

A

Question 3

Sliding compound miter saws come in sizes ranging __.

A)6 1/2 to 7 1/4 inch
B)6 1/2 to 10 inch
C)7 1/4 to 12 inch
D)8 1/2 to 12 inch

Answer 3

D

Question 4

The common table saw found on the job is the __.

A)8 inch model
B)10 inch model
C)12 inch model
D)14 inch model

Question 5

Fences may be used on __.

A)table saws
B)band saws
C)jointers
D)all of the above

Question 6

The table saw tool best suited for cross cutting is the rip fence.

Question 7

The band saw cuts with a revolving strip of metal that has teeth.

Question 8

When ripping a narrow strip a(n) __ is used to safely finish the cut.

A)push stick
B)miter gauge
C)rip fence
D)anti-kick back device

Question 9

Sliding compound miter saws can only cut miters.

Question 10

Dado blades are used to cut material with small kerfs.

Question 11

A ____ is constructed with two tables: infeed and outfeed.

A)plane
B)sander
C)jointer
D)finisher

Question 12

The jointer outfeed table is __.

A)adjustable
B)set to the height of the cutters
C)totally covered by the safety shield
D)all of the above

Question 13

A jointer is used to smooth stock surfaces to remove the marks made by sawing.

Question 14

It is often not necessary to disconnect the power cord when adjusting the fences on a stationary power tool.

Question 15

A ____ is a precision drilling tool consisting of a base, column, table, and head.

A)shaper
B)molder
C)filer
D)drill press

Question 16

It is often safe when operating a table saw to use the rip fence and miter gauge at the same time.

Question 17

When operating a table saw, proper feed rate is determined by listening to the blade speed.

Question 18

Small turning radii while using a band saw requires the use of 3/4" bands.

Question 19

The ____ saw is a tool designed to cut irregular shapes in various thicknesses of material.

A)miter
B)band
C)dado
D)crosscut

Question 20

____ sanders in the form of a drum, disk, and belt are designed to smooth most any shaped piece of work.

A)Bench
B)Transitional
C)Oscillating spindle
D)Combination

Question 21

A good safety habit is to adjust the table saw blade to about __________.above the stock.

Question 22

A saw blade designed to made wide cuts in wood is called a __________.

Question 23

Miter saws typically can be adjusted left or right to an angle of __________.

Question 24

The adjustable part of a jointer that determines the depth of cut is called the __________.

Question 25

A band saw band is held in proper position by __________.

Question 26

The term used to describe cutting boards into thinner pieces is called __________.

Question 27

A tool designed to make accurate repetitive holes in material is called __________.

Question 28

Safety shield of a jointer protects the operator from the __________.

Question 29

When using a jointer it is best to avoid placing fingers __________.

Question 30

The cutting operation that cuts wood with the grain is called __________.