Place the five steps for making a frequency polygon into the correct order: 1. Along the left side of the page (y-axis), make a scale of frequencies that ranges from 0 at the bottom to the highest frequency for any value.
2) Connect the points with lines.
3) Make a frequency table.
4) Mark a point above each value with a height for the frequency of that value.
5) Put the values along the bottom of the page (x-axis).
A)3, 5, 1, 4, 2
B)2, 3, 1, 4, 5
C)5, 3, 1, 2, 3
D)3, 5, 1, 2, 4

Question

Quizplus · Accepted Answer

The correct order for making a frequency polygon starts with making a frequency table (3), then placing values along the x-axis (5), setting up the frequency scale on the y-axis (1), marking points for each value's frequency (4), and finally connecting these points with lines (2).

Place the Five Steps for Making a Frequency Polygon into the Correct