In a brick veneer assembly, weep holes are required
A) immediately above the flashing.
B) at each alternate floor level.
C) at each floor level.
D) 2 in. above a flashing.
E) immediately below the flashing.
Correct Answer:
Verified
Q15: The minimum required width of the air
Q16: A steel angle used to support the
Q17: The backup wall in a brick veneer
Q18: The anchors in a brick veneer wall
Q19: In general, a CMU- backed brick veneer
Q21: In a brick veneer assembly with a
Q22: The GFRC skin is typically
A)1 in. to
Q23: A GFRC curtain wall panel consists of
A)a
Q24: The glass fibers used in the GFRC
Q25: The bricks used in brick- faced concrete
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents