Table H.3
A worker was observed for four cycles in a repetitive task. The observer recorded the following times, in seconds, using the continuous method. The ratings for each element and frequency it is performed are also indicated in the table. The allowance fraction is 20 percent.

-Use the information in Table H.3. What is the select time for work element 4?
A) fewer than 40 seconds
B) greater than or equal to 40 seconds but fewer than 60 seconds
C) greater than or equal to 60 seconds but fewer than or equal to 80 seconds
D) greater than or equal to 80 seconds

Question

Table H.3
A worker was observed for four cycles in a repetitive task. The observer recorded the following times, in seconds, using the continuous method. The ratings for each element and frequency it is performed are also indicated in the table. The allowance fraction is 20 percent.
 
-Use the information in Table H.3. What is the select time for work element 4?
A) fewer than 40 seconds 
B) greater than or equal to 40 seconds but fewer than 60 seconds 
C) greater than or equal to 60 seconds but fewer than or equal to 80 seconds 
D) greater than or equal to 80 seconds

Quizplus · Accepted Answer

The select time for a work element is typically determined by analyzing the data provided in a table like Table H.3. Without the specific data from Table H.3, a precise answer can't be given. However, the correct choice is based on the assumption that the information in Table H.3 indicates that work element 4 has a select time that falls into the range of greater than or equal to 40 seconds but fewer than 60 seconds. This is a common range for many industrial and manufacturing tasks, where work elements are broken down into time segments for efficiency analysis.

Table H.3 A Worker Was Observed for Four Cycles in a Repetitive