Technician A says that a pressed-fit cylinder sleeve usually has an I.D. that is smaller than the original bore size. Technician B says to clean the block thoroughly with solvent after honing. Who is right
A)Technician A only
B)Technician B only
C)Both A and B
D)Neither A nor B

Question

Quizplus · Accepted Answer

Technician A is correct because a pressed-fit cylinder sleeve is designed to be pressed into the block with a slightly smaller I.D. than the original bore size. Technician B is incorrect because cleaning the block with solvent after honing can cause residual solvent to contaminate the engine, leading to potential issues. Instead, the block should be thoroughly cleaned with hot soapy water and rinsed in hot water before assembly.

Technician a Says That a Pressed-Fit Cylinder Sleeve Usually Has