When would GTA welding be a good choice for making pipe welds?
A) When the joint must have a high degree of integrity.
B) If the joint has too narrow of a root gap.
C) If the joint has too wide of a root gap.
D) For 6G pipe joints and when pipe flanges are being installed at the ends of pipe runs.
Correct Answer:
Verified
Q1: To purge the air out of a
Q12: To contain backing gas in a pipe
Q22: What can be done to make it
Q29: What might affect the selection of the
Q31: What does making deep penetration on the
Q33: The _ of the root surface results
Q36: A concave root surface is sometimes known
Q37: What is the weld pass that can
Q37: The _ of a weld is the
Q38: What is the most commonly used groove
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents