The shop manual should have a picture of the head bolt tightening sequence. However, if there is no shop manual or technical data available, what would the best tightening sequence be?
A) Go from left to right all of the top row (intake side) first, then tighten all of the bottom row (exhaust) bolts right to left
B) Go from left to right all of the bottom row bolts (exhaust side) first, then tighten all of the top row (intake) bolts right to left
C) Go in a circular pattern beginning in the center and ending on the outboard ends
D) Go in a circular pattern working from the outside toward the center
Correct Answer:
Verified
Q1: Tightening of a bolt should be done
Q2: The proper engine break-in procedure is a
Q3: All head bolts in an engine are
Q5: Technician A says cork gaskets are used
Q6: When lubrication of a fastener is recommended
Q7: Gasket sealants should be used on all
Q8: After the break-in period, the cylinder head
Q9: Elasticity means that a bolt can be
Q10: A gasket installed upside down or reversed
Q11: What should be done to correct bolt
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents