The third and fourth lines of the rafter table on most framing squares are used to calculate the length of ____ rafters.
A) hip
B) jack
C) valley
D) common
Correct Answer:
Verified
Q11: The line where two pitched roofs meet
Q12: The length of the valley rafters is
Q13: The rafter that follows the valley is
Q14: Valley rafters always have a tail.
Q15: Hip jack rafters are lengthened at the
Q17: The rafters that butt against the hip
Q18: The hip rafters are never made of
Q19: The length of each jack rafter in
Q20: The valley rafter is at a _
Q21: If the valley flashing is not wide
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents