A connecting rod is being inspected and measured for reuse. Technician A says that the big end of the connecting rod should be measured for out-of-round and taper. Technician B says that a special alignment tool must be used when measuring for twist. Who is correct?
A) A only
B) B only
C) Both A and B
D) Neither A nor B
Correct Answer:
Verified
Q1: Technician A says that there should be
Q3: During operation of an engine, the crankshaft
Q4: Of the three main types of piston
Q5: Bearings from an engine are being inspected.
Q6: Technician A says if the piston ring
Q7: All piston pins are positioned exactly in
Q8: A crankshaft has just been installed into
Q9: All of the following are normal repairs
Q10: When a main bearing is installed, the
Q11: Full-floating piston pins are held in by
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents