Which command will successfully configure Ethernet5 to be 40Gbps on an Arista 7150-52 switch?

Question

Quizplus · Accepted Answer

The correct command to configure Ethernet5 to be 40Gbps is: Arista(config-if-Et5)# speed forced 40gfull. This forces the speed to be 40Gbps instead of relying on auto-negotiation. Option A is incorrect because the Arista 7150-52 does support 40Gbps. Option B is incorrect because it assumes that a port can only support speeds equal to or less than its current speed. Option D is incorrect because it repeats the same command twice.

Which Command Will Successfully Configure Ethernet5 to Be 40Gbps on an Arista