While setting up an AXIS Q7404 Video Encoder for control of an analog PTZ using Pelco D protocol, you run into a problem. After uploading of the proper Pelco drivers into the AXIS Q7404 Video Encoder you find that channel 1 is controlling the wrong analog PTZ. Which option below would you adjust to fix this problem so you can avoid changing physical cables?
A) IP address
B) Device ID
C) Baud rate
D) Device type

Question

Quizplus · Accepted Answer

The Device ID of the PTZ needs to be adjusted to match the assigned channel on the video encoder. This will ensure that the correct PTZ is being controlled by the correct channel.

While Setting Up an AXIS Q7404 Video Encoder for Control