After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.
A) set interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop gateway address 192.168.80.1 on save config
B) add interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 add static-route 0.0.0.0.0.0.0.0 gw 192.168.80.1 on
C) set interface Mgmt ipv4-address 192.168.80.200 255.255.255.0
D) add interface Mgmt ipv4-address 192.168.80.200 mask-length 24 add static-route default nexthop gateway address 192.168.80.1 on
Correct Answer:
Verified
Q390: Which icon indicates in the WebUI that
Q391: Which option, when applied to a rule,
Q392: One of major features in R80 SmartConsole
Q393: Back up and restores can be accomplished
Q394: Which Threat Prevention Software Blade provides protection
Q396: You are going to perform a major
Q397: Which Identity Source(s) should be selected in
Q398: What is the purpose of the CPCA
Q399: What is the purpose of the Clean-up
Q400: What are the two types of NAT
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents