Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?
A) The link becomes an access port.
B) The link is in an error disabled state.
C) The link is in a down state.
D) The link becomes a trunk port.

Question

Quizplus · Accepted Answer

Dynamic Desirable actively attempts to convert the link to a trunk, and Dynamic Auto will passively agree to become a trunk if the other side requests it. Therefore, the link becomes a trunk port.

Two Switches Are Connected and Using Cisco Dynamic Trunking Protocol