Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?
A) RSPAN session 1 is incompletely configures for monitoring.
B) RSPAN session 1 monitors activity on VLAN 50 of a remote switch.
C) SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
D) SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.

Question

Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?
A) RSPAN session 1 is incompletely configures for monitoring. 
B) RSPAN session 1 monitors activity on VLAN 50 of a remote switch. 
C) SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15. 
D) SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.

Quizplus · Accepted Answer

The Answer of  Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?
A) RSPAN session 1 is incompletely configures for monitoring. 
B) RSPAN session 1 monitors activity on VLAN 50 of a remote switch. 
C) SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15. 
D) SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.

Refer to the Exhibit