Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?
A) The port-channel mode should be set to auto.
B) The port channel on SW2 is using an incompatible protocol.
C) The port-channel trunk is not allowing the native VLAN.
D) The port-channel interface load balance should be set to src-mac.

Question

Refer to the exhibit.  A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?
A) The port-channel mode should be set to auto. 
B) The port channel on SW2 is using an incompatible protocol. 
C) The port-channel trunk is not allowing the native VLAN. 
D) The port-channel interface load balance should be set to src-mac.

Quizplus · Accepted Answer

The Answer of Refer to the exhibit.  A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?
A) The port-channel mode should be set to auto. 
B) The port channel on SW2 is using an incompatible protocol. 
C) The port-channel trunk is not allowing the native VLAN. 
D) The port-channel interface load balance should be set to src-mac.

Refer to the Exhibit