To enable Router A to communicate with loopback 0 on Router B on the network shown in the figure, which of the following commands needs to be run on Router A? 
A) ip route-static 10.2.2 32 GigabitEthernet 0/0/0
B) ip route-static 10.2.2 0 GigabitEthernet 0/0/0
C) ip route-static 10.0.2.2 255.255.255.255 10.0.12.2
D) ip route-static 10.0.2.2 255.255.255.255 10.0.12.1
Correct Answer:
Verified
Q341: What is the destination IP address of
Q342: Which of the following packets is used
Q343: Which of the following statements about VLANIF
Q344: Two routers are connected through serial interfaces
Q345: An MCU can belong to up to
Q347: User access layer is composed of various
Q348: )According to the different function modes of
Q349: Service Area( )indicates the area under the
Q350: If the "user-interface maximum-vty 0" command is
Q351: Segment routing (SR) defines destination address prefixes/nodes
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents