In the N8500 (V200R001) system, when you run the gabconfig -a command on a cluster node, the system displays the following figure. N8000V2R1-01-01 # gabconfig -a Port b gen bab409 membership 0123 Port f gen bab412 membership 0123 Port h gen bab40d membership 0123 Port v gen bab40d membership 0123 Port w gen bab40f membership 0123 You determine that the heartbeat members of the node is not started, you can use /etc/init.d/llt start to try to start it.

Question

Quizplus · Accepted Answer

The command "/etc/init.d/llt start" is used to start the LLT (Low Latency Transport) service, which is responsible for heartbeat communication in a cluster. If the heartbeat members are not started, this command can be used to attempt to start them.

In the N8500 (V200R001) System, When You Run the Gabconfig