Which Cisco IOS command(s) would be used to configure an interface in a static layer 3 EtherChannel?
A) channel-group number mode on
B) no switchport
C) channel-group number mode on layer-3
D) ip routing enable

Question

Quizplus · Accepted Answer

A) The channel-group number mode on command would be used to statically configure an interface into an EtherChannel; the no switchport command would configure it as layer 3.
B) The channel-group number mode on command would be used to statically configure an interface into an EtherChannel; the no switchport command would configure it as layer 3.

Which Cisco IOS Command(s) Would Be Used to Configure an Interface