When using composite positional tolerancing the upper part of the feature control frame is the _____________________ control and specifies the larger positional tolerance for the pattern of features as a group. The lower entry is called the ____________________ control and specifies the smaller positional tolerance for the individual features within the pattern.
Correct Answer:
Verified
View Answer
Unlock this answer now
Get Access to more Verified Answers free of charge
Q100: When locating holes using positional tolerancing, the
Q101: _ dimensioning combines angular dimensions with other
Q102: List the five types of geometric tolerances.
Q103: An _ tolerance splits the tolerance zone
Q104: This is the actual feature of the
Q106: Give the general note that should be
Q107: What are the three characteristics of the
Q108: List the five types into which geometric
Q109: Identify the primary standard published by the
Q110: A numerical value used to describe the
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents