Question 1

________________ dimensioning combines angular dimensions with other dimensions to locate features from planes, centerlines, or center planes.

Accepted Answer

The answer of ________________ dimensioning combines angular dimensions with other...

Question 2

List the five types of geometric tolerances.

Accepted Answer

The answer of List the five types of geometric tolerances....

Question 3

An ___________________________ tolerance splits the tolerance zone on each side of true profile, but the distance on each side is not equal.

Accepted Answer

The answer of An ___________________________ tolerance splits the tolerance zone...

Question 4

This is the actual feature of the part that is used to establish the datum.

Accepted Answer

The answer of This is the actual feature of the...

Question 5

When using composite positional tolerancing the upper part of the feature control frame is the _____________________ control and specifies the larger positional tolerance for the pattern of features as a group. The lower entry is called the ____________________ control and specifies the smaller positional tolerance for the individual features within the pattern.

Accepted Answer

The answer of When using composite positional tolerancing the upper...

Question 6

Give the general note that should be found on all based on the ASME Y14.5-2009.

Accepted Answer

The answer of Give the general note that should be...

Question 7

What are the three characteristics of the orientation tolerance?

Accepted Answer

The answer of What are the three characteristics of the...

Question 8

List the five types into which geometric tolerancing symbols are divided.

Accepted Answer

The answer of List the five types into which geometric...

Question 9

Identify the primary standard published by the American Society of Mechanical Engineers (ASME) that establishes uniform practices for stating and interpreting dimensioning, tolerancing, and related requirements for use on engineering drawings and related documents.

Accepted Answer

The answer of Identify the primary standard published by the...

Question 10

A numerical value used to describe the theoretically exact size, profile, orientation, or location of a feature or datum target. It is the basis from which permissible variations are established by tolerances on other dimensions, in notes, or in feature control frames.

Accepted Answer

The answer of A numerical value used to describe the...

Question 11

What are the four characteristics of the form tolerance?

Accepted Answer

The answer of What are the four characteristics of the...

Question 12

An ___________________________ tolerance splits the tolerance zone equally on each side of true profile.

Accepted Answer

The answer of An ___________________________ tolerance splits the tolerance zone...

Question 13

This is a point, axis, line, or plane consistent with or resulting from processing or inspection equipment, such as a surface plate, inspection table, gage surface, or a mandrel.

Accepted Answer

The answer of This is a point, axis, line, or...

Question 14

A ___________ profile tolerance is where the entire tolerance zone is on one side of the true profile.

Accepted Answer

The answer of A ___________ profile tolerance is where the...

Question 15

_________________ tolerancing is used when it is desirable to permit the location of a pattern of features to vary within a larger tolerance than the positional tolerance specified for each feature.

Accepted Answer

The answer of _________________ tolerancing is used when it is...

Question 16

A group of features is referred to as a _____________________________ when they are located relative to common datum features not subject to size tolerance, or to common datum features of size specified on an RFS basis.

Accepted Answer

The answer of A group of features is referred to...

Question 17

The _________________ or actual desired shape of the object is the basis of the profile tolerance.

Accepted Answer

The answer of The _________________ or actual desired shape of...

Question 18

________________ dimensioning uses linear dimensions to locate features from planes, centerlines, or center planes.

Accepted Answer

The answer of ________________ dimensioning uses linear dimensions to locate...

Question 19

This is the smallest size that can be contracted about an external feature or the largest size that can be expanded within an internal feature.

Accepted Answer

The answer of This is the smallest size that can...

Question 20

What are the two characteristics of the runout tolerance?

Accepted Answer

The answer of What are the two characteristics of the...

Quiz 11: Reading Geometric Dimensioning and Tolerancing