When using the spray metal transfer method, what can happen if the tip gets too close to the work?
A) The wire may arc out and cause a lot of spatter to be thrown from the weld.
B) The shorter stickout will cause the weld to get hotter due to the reduced resistance in the shorter wire and the weld will become wider and more fluid.
C) The tip may be melted.
D) A flood of sparks as the weld pool is overheated will erupt.
Correct Answer:
Verified
Q23: Filler passes only need to have complete
Q24: What can be done to protect the
Q25: If the contact tube tip melts, the
Q26: What should the gun angle and travel
Q27: It is important that tack welds be
Q29: Although the welded pipe seam is _,
Q30: The inside and outside pipe surfaces must
Q31: The ends of the tack welds must
Q32: The cover pass cannot be any wider
Q33: Unless a backing ring is used, most
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents