Short Answer
The inside and outside pipe surfaces must be ground clean back ________ from the joint.
Correct Answer:
Verified
Related Questions
Q25: If the contact tube tip melts, the
Q26: What should the gun angle and travel
Q27: It is important that tack welds be
Q28: When using the spray metal transfer method,
Q29: Although the welded pipe seam is _,
Q31: The ends of the tack welds must
Q32: The cover pass cannot be any wider
Q33: Unless a backing ring is used, most
Q34: Describe how the end of a pipe
Q35: A small flat surface of 1/16-in. (1.6
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents