Question 1

When the cutting plane extends entirely through the object (view) in a straight line and the front half is theoretically removed, a ____________________ section results.

Accepted Answer

full

Question 2

The abbreviation for countersink is ____________________.

Accepted Answer

CSK

Question 3

The abbreviation DP may be used in place of the depth symbol.

Accepted Answer

DP is commonly used as an abbreviation for depth.

Question 4

General-use section lining may also be used to represent ____.
A) steel
B) cast iron
C) aluminum
D) bronze

Accepted Answer

The answer of General-use section lining may also be used...

Question 5

The symbol for counterbore or spotface is ____.
A) 
B) 
C) 
D)

Accepted Answer

The answer of The symbol for counterbore or spotface is...

Question 6

The symbol for countersink is ____.
A) 
B) 
C) 
D)

Accepted Answer

The answer of The symbol for countersink is ____.
A) 
B)...

Question 7

In a sectional view, the exposed or cut surface is identified by crosshatching or ______________________________.

Accepted Answer

The answer of In a sectional view, the exposed or...

Question 8

Members such as ribs and arms that blend into other features end in curves called runouts.

Accepted Answer

This is true, runouts are curves that occur where one feature transitions into another, such as where a rib blends into the rest of the body.

Question 9

Sectional views may also be called ____________________.

Accepted Answer

The answer of Sectional views may also be called ____________________....

Question 10

A counterbore is an area where the surface is machined just enough to provide a level seating surface for a fastener.

Accepted Answer

The answer of A counterbore is an area where the...

Question 11

Arrowheads on the ends of cutting-plane lines indicate the ______________________________.

Accepted Answer

The answer of Arrowheads on the ends of cutting-plane lines...

Question 12

When one fourth of an object is removed, the resulting sectional view is a(n) ____.
A) half section
B) quarter section
C) broken-out section
D) offset section

Accepted Answer

The answer of When one fourth of an object is...

Question 13

The abbreviation C'BORE may be used in place of the  symbol.

Accepted Answer

The answer of The abbreviation C'BORE may be used in...

Question 14

The cutting plane is always represented by a cutting-plane line.

Accepted Answer

The cutting plane is a theoretical plane used in technical drawings and is not typically represented by a line in the drawing.

Question 15

The symbol for deep or depth is ____.
A) 
B) 
C) 
D)

Accepted Answer

The answer of The symbol for deep or depth is...

Quiz 10: Sectional Views

When the cutting plane extends entirely through the object (view) in a straight line and the front half is theoretically removed, a ____________________ section results.

The abbreviation for countersink is ____________________.

The abbreviation DP may be used in place of the depth symbol.

General-use section lining may also be used to represent ____.

The symbol for counterbore or spotface is ____.

The symbol for countersink is ____.

In a sectional view, the exposed or cut surface is identified by crosshatching or ______________________________.

Members such as ribs and arms that blend into other features end in curves called runouts.

Sectional views may also be called ____________________.

A counterbore is an area where the surface is machined just enough to provide a level seating surface for a fastener.

Arrowheads on the ends of cutting-plane lines indicate the ______________________________.

When one fourth of an object is removed, the resulting sectional view is a(n) ____.

The abbreviation C'BORE may be used in place of the symbol.

The cutting plane is always represented by a cutting-plane line.

The symbol for deep or depth is ____.