Question 1

No handhole shall be required in a metal pole, supporting a luminaire, that is _________$\mathrm{ft}$ or less in height above grade that is provided with a hinged base.

Accepted Answer

20

Question 2

Where run across the top of floor joists, or within _________$\mathrm{ft}$ of the floor or floor joists across the face of rafters or studding, in an attic that has permanent stairs, nonmetallic-sheathed cable shall be protected by substantial guard strips that are at least as high as the cable.

Accepted Answer

7. Section 334.23 states that nonmetallic-sheathed cable installed in attics must comply with 320.23 .

Question 3

Mandatory NEC rules are those that identify actions that are specifically required or prohibited and are characterized by the use or the terms_________

Accepted Answer

shall or shall not

Question 4

In other than dwelling units, in addition to other arcflash hazard warning requirements in this section, a permanent label shall be field or factory applied to service equipment rated _________amps or more.

Accepted Answer

The answer of In other than dwelling units, in addition...

Question 5

A location temporarily subject to dampness or wetness, as in the case of a building under construction, is classified as a(n)_________ location.

Accepted Answer

The answer of A location temporarily subject to dampness or...

Question 6

Kitchen countertop receptacle outlets shall be installed so that no point along the wall line is more than in_________., measured horizontally from a receptacle outlet in that space.

Accepted Answer

The answer of Kitchen countertop receptacle outlets shall be installed...

Question 7

In hazardous (classified) locations, NPT threaded entries into explosionproof equipment shall be made up with at least_________ threads fully engaged.

Accepted Answer

The answer of In hazardous (classified) locations, NPT threaded entries...

Question 8

The disconnecting means for motor circuits rated 1000 volts, nominal, or less, shall have an ampacity rating of at least_________ of the motor.

Accepted Answer

The answer of The disconnecting means for motor circuits rated...

Question 9

The life safety and critical branches of the hospital essential electrical system shall be installed and connected to the alternate power source specified in $517.30(A)$ and (B) so that all functions specified herein for the life safety and critical branches are automatically restored to operation within_________ after interruption of the normal source.

Accepted Answer

The answer of The life safety and critical branches of...

Question 10

Where an equipment bonding jumper is installed on the outside of a raceway, the length shall not exceed  _________ $\mathrm{ft}$ and shall be routed with the raceway or enclosure.

Accepted Answer

The answer of Where an equipment bonding jumper is installed...

Question 11

A surface-mounted incandescent or LED luminaire installed on the ceiling of a clothes closet must have a minimum clearance of_________ in. between the luminaire and the nearest point of the closet storage space.

Accepted Answer

The answer of A surface-mounted incandescent or LED luminaire installed...

Question 12

Where cable trays support individual conductors and where the conductors pass from one cable tray to another, or from a cable tray to raceways or to equipment where the conductors are terminated, the distance between cable trays or between the cable tray and the equipment shall not exceed_________ $\mathrm{ft}$

Accepted Answer

The answer of Where cable trays support individual conductors and...

Question 13

In dwelling units, hallways of _________$\mathrm{ft}$ or more in length shall have at least one receptacle outlet.

Accepted Answer

The answer of In dwelling units, hallways of _________$\mathrm{ft}$ or...

Question 14

A bathroom is an area that includes:
I. a tub and a toilet.
II. a basin and a toilet.
III. a toilet and a shower.

Accepted Answer

The answer of A bathroom is an area that includes:
I....

Question 15

An outdoor motor fuel dispensing device is considered to be a Class I, Division 2 location up to_________ in. above grade level within _________$\mathrm{ft}$ horizontally in all directions from the dispenser enclosure.

Accepted Answer

The answer of An outdoor motor fuel dispensing device is...

Question 16

Where nonmetallic-sheathed cable is run at angles with joists in unfinished basements and crawl spaces, it shall be permissible to secure cables not smaller than two _________conductors directly to the lower edges of the joists.

Accepted Answer

The answer of Where nonmetallic-sheathed cable is run at angles...

Question 17

The ampacity of the supply conductors for a resistance welder that may be operated at different times at different values of primary current or duty cycle shall not be less than _________of the rated primary current for seam and automatically fed welders.

Accepted Answer

The answer of The ampacity of the supply conductors for...

Question 18

Service conductors installed as open conductors shall have a clearance of not less than_________ $\mathrm{ft}$ from windows that are designed to be opened.

Accepted Answer

The answer of Service conductors installed as open conductors shall...

Question 19

The_________ is the connection between the grounded circuit conductor and the equipment grounding conductor at the service.

Accepted Answer

The answer of The_________ is the connection between the grounded...

Question 20

Installations within or behind a surface of noncombustible material, boxes shall be made so that the front edge of the box will not be set back of the finished surface more than_________ in.

Accepted Answer

The answer of Installations within or behind a surface of...

Quiz 1: National Electrical Code

No handhole shall be required in a metal pole, supporting a luminaire, that is _________ $\mathrm{ft}$ or less in height above grade that is provided with a hinged base.

Where run across the top of floor joists, or within _________ $\mathrm{ft}$ of the floor or floor joists across the face of rafters or studding, in an attic that has permanent stairs, nonmetallic-sheathed cable shall be protected by substantial guard strips that are at least as high as the cable.

Mandatory NEC rules are those that identify actions that are specifically required or prohibited and are characterized by the use or the terms_________

In other than dwelling units, in addition to other arcflash hazard warning requirements in this section, a permanent label shall be field or factory applied to service equipment rated _________amps or more.

A location temporarily subject to dampness or wetness, as in the case of a building under construction, is classified as a(n)_________ location.

Kitchen countertop receptacle outlets shall be installed so that no point along the wall line is more than in_________., measured horizontally from a receptacle outlet in that space.

In hazardous (classified) locations, NPT threaded entries into explosionproof equipment shall be made up with at least_________ threads fully engaged.

The disconnecting means for motor circuits rated 1000 volts, nominal, or less, shall have an ampacity rating of at least_________ of the motor.

Where an equipment bonding jumper is installed on the outside of a raceway, the length shall not exceed _________ $\mathrm{ft}$ and shall be routed with the raceway or enclosure.

A surface-mounted incandescent or LED luminaire installed on the ceiling of a clothes closet must have a minimum clearance of_________ in. between the luminaire and the nearest point of the closet storage space.

In dwelling units, hallways of _________ $\mathrm{ft}$ or more in length shall have at least one receptacle outlet.

A bathroom is an area that includes: I. a tub and a toilet. II. a basin and a toilet. III. a toilet and a shower.

An outdoor motor fuel dispensing device is considered to be a Class I, Division 2 location up to_ in. above grade level within _ $\mathrm{ft}$ horizontally in all directions from the dispenser enclosure.

Where nonmetallic-sheathed cable is run at angles with joists in unfinished basements and crawl spaces, it shall be permissible to secure cables not smaller than two _________conductors directly to the lower edges of the joists.

The ampacity of the supply conductors for a resistance welder that may be operated at different times at different values of primary current or duty cycle shall not be less than _________of the rated primary current for seam and automatically fed welders.

Service conductors installed as open conductors shall have a clearance of not less than_________ $\mathrm{ft}$ from windows that are designed to be opened.

The_________ is the connection between the grounded circuit conductor and the equipment grounding conductor at the service.

Installations within or behind a surface of noncombustible material, boxes shall be made so that the front edge of the box will not be set back of the finished surface more than_________ in.

Quiz 1: National Electrical Code

No handhole shall be required in a metal pole, supporting a luminaire, that is _________ ft\mathrm{ft}ft or less in height above grade that is provided with a hinged base.

Where run across the top of floor joists, or within _________ ft\mathrm{ft}ft of the floor or floor joists across the face of rafters or studding, in an attic that has permanent stairs, nonmetallic-sheathed cable shall be protected by substantial guard strips that are at least as high as the cable.

Mandatory NEC rules are those that identify actions that are specifically required or prohibited and are characterized by the use or the terms_________

In other than dwelling units, in addition to other arcflash hazard warning requirements in this section, a permanent label shall be field or factory applied to service equipment rated _________amps or more.

A location temporarily subject to dampness or wetness, as in the case of a building under construction, is classified as a(n)_________ location.

Kitchen countertop receptacle outlets shall be installed so that no point along the wall line is more than in_________., measured horizontally from a receptacle outlet in that space.

In hazardous (classified) locations, NPT threaded entries into explosionproof equipment shall be made up with at least_________ threads fully engaged.

The disconnecting means for motor circuits rated 1000 volts, nominal, or less, shall have an ampacity rating of at least_________ of the motor.

Where an equipment bonding jumper is installed on the outside of a raceway, the length shall not exceed _________ ft\mathrm{ft}ft and shall be routed with the raceway or enclosure.

A surface-mounted incandescent or LED luminaire installed on the ceiling of a clothes closet must have a minimum clearance of_________ in. between the luminaire and the nearest point of the closet storage space.

In dwelling units, hallways of _________ ft\mathrm{ft}ft or more in length shall have at least one receptacle outlet.

A bathroom is an area that includes: I. a tub and a toilet. II. a basin and a toilet. III. a toilet and a shower.

An outdoor motor fuel dispensing device is considered to be a Class I, Division 2 location up to_________ in. above grade level within _________ ft\mathrm{ft}ft horizontally in all directions from the dispenser enclosure.

Where nonmetallic-sheathed cable is run at angles with joists in unfinished basements and crawl spaces, it shall be permissible to secure cables not smaller than two _________conductors directly to the lower edges of the joists.

The ampacity of the supply conductors for a resistance welder that may be operated at different times at different values of primary current or duty cycle shall not be less than _________of the rated primary current for seam and automatically fed welders.

Service conductors installed as open conductors shall have a clearance of not less than_________ ft\mathrm{ft}ft from windows that are designed to be opened.

The_________ is the connection between the grounded circuit conductor and the equipment grounding conductor at the service.

Installations within or behind a surface of noncombustible material, boxes shall be made so that the front edge of the box will not be set back of the finished surface more than_________ in.

No handhole shall be required in a metal pole, supporting a luminaire, that is _________ $\mathrm{ft}$ or less in height above grade that is provided with a hinged base.

Where run across the top of floor joists, or within _________ $\mathrm{ft}$ of the floor or floor joists across the face of rafters or studding, in an attic that has permanent stairs, nonmetallic-sheathed cable shall be protected by substantial guard strips that are at least as high as the cable.

Where an equipment bonding jumper is installed on the outside of a raceway, the length shall not exceed _________ $\mathrm{ft}$ and shall be routed with the raceway or enclosure.

In dwelling units, hallways of _________ $\mathrm{ft}$ or more in length shall have at least one receptacle outlet.

An outdoor motor fuel dispensing device is considered to be a Class I, Division 2 location up to_ in. above grade level within _ $\mathrm{ft}$ horizontally in all directions from the dispenser enclosure.

Service conductors installed as open conductors shall have a clearance of not less than_________ $\mathrm{ft}$ from windows that are designed to be opened.