In a design specification 25 $\pm$ 1.5, the value 25 is called the ____, while $\pm$ 1.5 is called the ____.
A)nominal, reliability
B)average, tolerance
C)average, nominal
D)nominal, tolerance

Question

Quizplus · Accepted Answer

The value 25 is the nominal value, which is the desired or intended value of the parameter. On the other hand, F1F1F1S1F1F1F10 1.5 is the tolerance range, also known as the tolerance, which specifies the acceptable deviation from the nominal value. Therefore, the best choice is D, nominal and tolerance.

In a Design Specification 25 ±\pm± 15, the Value 25 Is Called the ____, While

In a Design Specification 25 $\pm$ 15, the Value 25 Is Called the ____, While