Question 1

Refer to the exhibit. Which route type is configured to reach the Internet?

Accepted Answer

The answer of  Refer to the exhibit. Which route...

Question 2

Which three statements about MAC addresses are correct? (Choose three.)

Accepted Answer

A MAC address is a unique identifier assigned to a network interface controller (NIC) for use as a network address in communications within a network segment. The MAC address is a 48-bit value that is typically written as a sequence of six hexadecimal digits, separated by colons (e.g., 0A:26:B8:D6:65:90). The first 24 bits of the MAC address identify the manufacturer of the NIC, and the remaining 24 bits are assigned by the manufacturer to uniquely identify the NIC.

Question 3

On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?

Accepted Answer

To allow communication between different VLANs, a router with subinterfaces configured on the physical interface connected to the switch is needed. This setup is known as "router-on-a-stick" and allows inter-VLAN routing.

Question 4

Which two pieces of information about a Cisco device can Cisco Discovery Protocol communicate? (Choose two.)

Accepted Answer

Cisco Discovery Protocol (CDP) is a Layer 2 protocol that allows Cisco devices to discover and communicate information about themselves to other Cisco devices on the same network. CDP can communicate the native VLAN and the VTP domain of a Cisco device.

Question 5

Which two statements about eBGP neighbor relationships are true? (Choose two.)

Accepted Answer

eBGP neighbor relationships are established between routers in different autonomous systems (ASes). Neighbors must be specifically declared in the configuration of each device.

Question 6

Which component of an Ethernet frame is used to notify a host that traffic is coming?

Accepted Answer

The preamble in an Ethernet frame is used to synchronize the receiver's clock and notify the host that traffic is coming.

Question 7

Which value is used to determine the active router in an HSRP default configuration?

Accepted Answer

The answer of Which value is used to determine the...

Question 8

Which value can you modify to configure a specific interface as the preferred forwarding interface?

Accepted Answer

The port priority can be modified to configure a specific interface as the preferred forwarding interface in network protocols like Spanning Tree Protocol (STP).

Question 9

Which two WAN architecture options help a business scalability and reliability for the network? (Choose two.)

Accepted Answer

The answer of Which two WAN architecture options help a...

Question 10

Refer to the exhibit. Which path is used by the router for Internet traffic?

Accepted Answer

The answer of  Refer to the exhibit. Which path...

Question 11

Which command must you enter to guarantee that an HSRP router with higher priority becomes the HSRP primary router after it is reloaded?

Accepted Answer

The "standby 10 preempt" command ensures that a router with a higher priority will take over as the HSRP primary router after it is reloaded.

Question 12

Which command is used to enable LLDP globally on a Cisco IOS ISR?

Accepted Answer

The command "lldp run" is used to enable LLDP (Link Layer Discovery Protocol) globally on Cisco IOS devices.

Question 13

Which command should you enter to configure an LLDP delay time of 5 seconds?

Accepted Answer

The command "lldp reinit 5" sets the LLDP reinitialization delay time to 5 seconds.

Question 14

You have two paths for the 10.10.10.0 network - one that has a feasible distance of 3072 and the other of 6144. What do you need to do to load balance your EIGRP routes?

Accepted Answer

The answer of You have two paths for the 10.10.10.0...

Question 15

Which technology is used to improve web traffic performance by proxy caching?

Accepted Answer

WSA (Web Security Appliance) is used to improve web traffic performance by proxy caching, among other security functions.

Question 16

After you deploy a new WLAN controller on your network, which two additional tasks should you consider? (Choose two.)

Accepted Answer

The answer of After you deploy a new WLAN controller...

Question 17

Refer to the exhibit. Which password must an engineer use to enter the enable mode?

Accepted Answer

The answer of  Refer to the exhibit. Which password...

Question 18

Refer to the exhibit. How will switch SW2 handle traffic from VLAN 10 on SW1?

Accepted Answer

The answer of Refer to the exhibit. How will switch...

Question 19

You are configuring your edge routers interface with a public IP address for Internet connectivity. The router needs to obtain the IP address from the service provider dynamically. Which command is needed on interface FastEthernet 0/0 to accomplish this?

Accepted Answer

The command "ip address dhcp" is used on a router interface to obtain an IP address dynamically from a DHCP server, which is typically provided by the service provider for Internet connectivity.

Question 20

Refer to the exhibit. Which route type does the routing protocol Code D represent in the output?

Accepted Answer