Question 1

Figure 8.1.1
For the circuit shown in Fig. 8.1.1, assume $Q_{1}$ and $Q_{2}$ are perfectly matched, and $Q_{3}, Q_{4}$, and $Q_{5}$ are perfectly matched. Also, assume all transistors have very high $\beta$ and $V_{A}$. Find $V_{1}, I$, and $V_{2}$.

Accepted Answer

Figure 8.1.2
The analysis is shown on Fig. 8.1.2.

Question 2

Given the availability of NMOS and PMOS transistors that are matched and have $k_{n}=k_{p}=$ $5 \mathrm{~mA} / \mathrm{V}^{2}$ and $V_{A n}=-V_{A p}=5 \mathrm{~V}$, give circuits for the following amplifiers. In each case, find the output resistance and the voltage gain. In all cases, operate each transistor at a dc bias current of $100 \mu \mathrm{A}$ and give the value of $\left|V_{O V}\right|$ at which each transistor is operating.
(a) An NMOS common-source amplifier with a PMOS current-source load.
(b) An NMOS common-source amplifier with an NMOS cascode stage and a single-transistor PMOS current-source load. 
(c) An NMOS common-source amplifier with an NMOS cascode stage and a cascode PMOS current-source load.

Accepted Answer

For each transistor,
$$\begin{aligned}
k_{n} & =k_{p}=5 \mathrm{~mA} / \mathrm{V}^{2} \
V_{A n} & =-V_{A p}=5 \mathrm{~V} \
I_{D} & =100 \mu \mathrm{A}
\end{aligned}$$
$$\begin{aligned}
I_{D} & =\frac{1}{2} k\left|V_{O V}\right|^{2} \
0.1
 & =\frac{1}{2} \times 5 \times\left|V_{O V}\right|^{2} \
\Rightarrow\left|V_{O V}\right| & =0.2 \mathrm{~V} \
g_{m} & =\frac{2 I_{D}}{\left|V_{O V}\right|}=\frac{2 \times 0.1}{0.2}=1 \mathrm{~mA} / \mathrm{V} \
r_{O} & =\frac{\left|V_{A}\right|}{I_{D}}=\frac{5}{0.1}=50 \mathrm{k} \Omega
\end{aligned}$$
(a)
  
Figure 8.2.1
See Figure 8.2.1.
$$\begin{aligned}
& R_{o}=r_{o n}\left\|r_{o p}=50\right\| 50=25 \mathrm{k} \Omega \
& A_{V}=-g_{m} R_{O}=-1 \times 25=-25 \mathrm{~V} / \mathrm{V}
\end{aligned}$$
(b)

Figure 8.2.2
$$\begin{aligned}
R_{O 2} & \simeq\left(g_{m 2} r_{o 2}\right) r_{o 1} \
& =(1 \times 50) \times 50=2500 \mathrm{k} \Omega \
R_{O 3} & =r_{o 3}=50 \mathrm{k} \Omega \
R_{O} & =R_{O 2}\left\|R_{O 3}=50\right\| 2500=49 \mathrm{k} \Omega \
A_{v} & =-g_{m 1} R_{O}=-1 \times 49=-49 \mathrm{~V} / \mathrm{V}
\end{aligned}$$
(c)

Figure 8.2.3
$$\begin{aligned}
R_{o 2} \simeq\left(g_{m 2} r_{o 2}\right) r_{o 1} & =(1 \times 50) \times 50=2500 \mathrm{k} \Omega \
R_{O 3} \simeq\left(g_{m 3} r_{o 3}\right) r_{o 4} & =(1 \times 50) \times 50=2500 \mathrm{k} \Omega \
R_{O}=R_{O 2} \| R_{O 3} & =2500 \| 2500=1250 \mathrm{k} \Omega \
A_{v}=-g_{m 1} R_{O} & =-1 \times 1250=-1250 \mathrm{~V} / \mathrm{V}
\end{aligned}$$

Question 3

Figure 8.3.1
Design the double-cascode current source shown in Fig. 8.3.1 to provide $I=0.2 \mathrm{~mA}$ and the largest possible signal swing at the output; that is, design for the minimum allowable voltage across each transistor. The CMOS fabrication process available has $\left|V_{t p}\right|=0.4 \mathrm{~V},\left|V_{A}^{\prime}\right|=6 \mathrm{~V} / \mu \mathrm{m}$, and $\mu_{p} C_{o x}=100 \mu \mathrm{A} / \mathrm{V}^{2}$. Use devices with $L=$ $0.4 \mu \mathrm{m}$, and operate at $\left|V_{O V}\right|=0.2 \mathrm{~V}$.
(a) Specify $V_{G 1}, V_{G 2}$, and $V_{G 3}$.
(b) Find the $W / L$ ratios of the transistors.
(c) What is the value of $R_{O}$ achieved?
(d) What is the maximum allowable voltage at the current-source output?
(e) If this current source is used as the load of an NMOS double-cascode amplifier having a shortcircuit transconductance of $2 \mathrm{~mA} / \mathrm{V}$ and an output resistance equal to $R_{O}$ of the current source, what voltage gain is obtained?

Accepted Answer

Figure 8.3.2
(a) Refer to Figure 8.3.2. For $\left|V_{t p}\right|=0.4 \mathrm{~V}$ and $\left|V_{O V}\right|=0.2 \mathrm{~V}, V_{S G}=0.6 \mathrm{~V}$ and the minimum required $V_{S D}$ for each transistor is $0.2 \mathrm{~V}$. Thus,
$V_{G 1}=+1.2 \mathrm{~V}, \quad V_{G 2}=+1.0 \mathrm{~V}, \quad$ and $\quad V_{G S}=+0.8 \mathrm{~V}$
(b)
$$\begin{aligned}
I_{D} & =\frac{1}{2} \mu_{p} C_{O x}\left(\frac{W}{L}\right)\left|V_{O V}\right|^{2} \
0.2
 & =\frac{1}{2} \times 0.1 \times \frac{W}{L} \times 0.2^{2} \
\Rightarrow \frac{W}{L} & =100
\end{aligned}$$
(c)
$$\begin{aligned}
r_{o 1} & =\frac{\left|V_{A}\right|}{I_{D}}=\frac{\left|V_{A}^{\prime}\right| L}{I_{D}}=\frac{6 \times 0.4}{0.2}=12 \mathrm{k} \Omega \
r_{o 2} & =r_{o 3}=r_{o 1}=12 \mathrm{k} \Omega \
g_{m 2} & =g_{m 3}=\frac{2 I_{D}}{\left|V_{O V}\right|}=\frac{2 \times 0.2}{0.2}=2 \mathrm{~mA} / \mathrm{V} \
R_{o 2} & =\left(g_{m 2} r_{o 2}\right) r_{o 1}=(2 \times 12) \times 12=288 \mathrm{k} \Omega \
R_{o 3} & =\left(g_{m 3} r_{o 3}\right) R_{o 2}=(2 \times 12) \times 288=6912 \mathrm{k} \Omega
\end{aligned}$$
(d)
$$v_{O \max }=0.8+0.4=+1.2 \mathrm{~V}$$
(e)
$$\begin{aligned}
A_{v} & =-G_{m}\left(R_{O} \| R_{O}\right) \
& =-2(6912 \| 6912)=-6912 \mathrm{~V} / \mathrm{V}
\end{aligned}$$

Question 4

Figure 8.4.1
The cascode current source in Fig. 8.4.1 utilizes two identical PMOS transistors fabricated in a 0.18 - $\mu \mathrm{m}$ CMOS process for which $V_{D D}=1.8 \mathrm{~V}$, $V_{t p}=-0.5 \mathrm{~V}, V_{A}^{\prime}=-6 \mathrm{~V} / \mu \mathrm{m}$, and $\mu_{p} C_{o x}=$ $100 \mu \mathrm{A} / \mathrm{V}^{2}$.
Design the circuit to obtain $I=50 \mu \mathrm{A}$ and $R_{O}=1 \mathrm{M} \Omega$ and to allow for the maximum possible voltage swing at the output terminal of the current source. Utilize $\left|V_{O V}\right|=0.2 \mathrm{~V}$. Specify the values of $L$ and $W / L$ for $Q_{1}$ and $Q_{2}$. As well, specify the required values of the dc bias voltages $V_{G 1}$ and $V_{G 2}$. What is the maximum allowable voltage at the output?

Accepted Answer

The answer of

Figure 8.4.1
The cascode current source in...

Question 5

Figure 8.5.1
The modified Wilson current mirror of Fig. 8.5.1 utilizes four matched transistors for which $V_{t}=$ $0.4 \mathrm{~V}, \mu_{n} C_{o x}=400 \mu \mathrm{A} / \mathrm{V}^{2}$, and $V_{A}=3 \mathrm{~V}$. It is required to design the circuit so that $I_{O}=0.2 \mathrm{~mA}$ with all transistors operating at $V_{O V}=0.2 \mathrm{~V}$.
(a) Find the required value of $R$.
(b) Find the required value of the $W / L$ ratio for each of the four transistors.
(c) Find the value of the output resistance $R_{O}$.
(d) What is the minimum voltage permitted at the output?

Accepted Answer

The answer of

Figure 8.5.1
The modified Wilson current mirror...

Quiz 4: Building Blocks of Integrated-Circuit Amplifiers