Question 1

You are rebuilding a 62TE transmission. You test the overdrive solenoid and find the resistance is 5 ohms. Tech A states that the overdrive solenoid is within specification. Tech B states that the entire solenoid pack will need to be replaced. Who is correct?

Accepted Answer

The answer of You are rebuilding a 62TE transmission. You...

Question 2

You have a vehicle come in with a complaint of harsh shifting. You measure line pressure and find that it is high. You look at the scan tool and find that the pressure control solenoid is commanded to 62%. Tech A states that the TCM is commanding the transmission to maximum line pressure. Tech B states that the TCM is commanding 62% of line pressure. Who is correct?

Accepted Answer

The answer of You have a vehicle come in with...

Question 3

Two technicians are discussing the 62TE transmission. Tech A states that the 6 speed transmission has 7 forward gear ratios and 1 reverse ratio. Tech B states that the transmission has 6 forward gear ratios and 1 reverse ratio. Who is correct?

Accepted Answer

The answer of Two technicians are discussing the 62TE transmission....

Question 4

A vehicle comes in with no reverse. Tech A states that the vehicle could have a problem with the reverse clutch. Tech B states that the vehicle could have a problem with the low clutch. Who is correct?

Accepted Answer

The reverse clutch is directly involved in enabling the reverse gear in a vehicle. If there is a problem with the reverse clutch, it can prevent the vehicle from going into reverse. The low clutch is not typically involved in reverse gear operation.

Question 5

Technician A says that the 62TE transmission needs a special tool to determine the fluid level. Technician B says that an old speedometer cable can be used as a transmission fluid dipstick. Who is correct?

Accepted Answer

The answer of Technician A says that the 62TE transmission...

Question 6

Technician A says that the 62TE transmission has seven forward gear ratios. Technician B says that the seventh forward gear is used to make a smooth downshift from the sixth gear at highway speeds. Who is correct?

Accepted Answer

Both technicians are correct. The 62TE transmission has seven forward gear ratios, and the seventh forward gear is used to make a smooth downshift from the sixth gear at highway speeds.

Question 7

Technician A says that the 62TE transmission utilizes a double swap shift. Technician B says that the sensors in the transmission are used to determine any gear ratio errors. Who is correct?

Accepted Answer

Both technicians are correct. The 62TE transmission does utilize a double swap shift, and the sensors in the transmission are used to determine any gear ratio errors.

Question 8

Technician A says that the 62TE transmission uses a transmission range switch with four separate switches that identify the current gear selected by the driver. Technician B says that these switches will either be open or closed. Who is correct?

Accepted Answer

The 62TE transmission uses a transmission range switch with four separate switches to identify the gear selected, and these switches operate by being either open or closed.

Question 9

Technician A says that there are five pressure switches built into the solenoid body assembly that are monitored by the PCM to verify correct clutches are applied. Technician B says that the five pressure solenoids are supplied 12 volts and should have a resistance of 300 ohms with pressure applied to them. Who is correct?

Accepted Answer

Technician A is correct because the PCM monitors pressure switches to verify clutch application. Technician B is incorrect about the resistance value and voltage supply for pressure solenoids.

Question 10

Identify the type of transmission fluid that is required by 62TE.

Accepted Answer

The 62TE transmission requires ATF+4 fluid, which is a specific type of automatic transmission fluid designed for certain Chrysler vehicles.

Question 11

The 62TE is a ________ front-wheel drive transmission.

Accepted Answer

The 62TE is a 6-speed front-wheel drive transmission used in various vehicles.

Question 12

Tech A states that the 62TE transmission design is based upon the 41TE transmission. Tech B states that 62TE transmission design is based upon the 42RLE transmission. Who is correct?

Accepted Answer

The 62TE transmission is indeed based on the 41TE transmission design, not the 42RLE.

Question 13

Identify the component of 62TE transmission shown in the given figure

Accepted Answer

The answer of Identify the component of 62TE transmission shown...

Question 14

Tech A states that the additional gear ratios in the 62TE were created by replacing the transfer shaft in the 41TE. Tech B states that 62TE retains the transfer shaft used in the 41TE. Who is correct?

Accepted Answer

The answer of Tech A states that the additional gear...

Question 15

When using an old speedometer cable to check the transmission fluid level of 62TE, a paint marker should be used to mark a line at ________ from the end of the cable.

Accepted Answer

The answer of When using an old speedometer cable to...

Question 16

An old speedometer cable is used to check the transmission fluid level of 62TE. Tech A states that the bottom of the cable should be marked at 20 and 30 mm. Tech B states that the bottom of the cable should be marked at 40 and 50 mm. Who is correct?

Accepted Answer

The answer of An old speedometer cable is used to...

Question 17

Tech A states that the entire speedometer cable needs to be inserted inside the transmission to check the fluid level. Tech B states that it is very easy to push the speedometer cable past the dipstick stop inside the transmission. Who is correct?

Accepted Answer

Tech B is correct because it is very easy to push the speedometer cable past the dipstick stop inside the transmission.

Question 18

Identify the transmission fluid level for a fluid temperature of 77 degree Fahrenheit.

Accepted Answer

At 77 degrees Fahrenheit, the transmission fluid level should be within the range of 25-38 mm, as this is the typical range for a fluid at that temperature.

Question 19

Identify the transmission fluid level for a fluid temperature of 138 degree Fahrenheit.

Accepted Answer

The transmission fluid level for a fluid temperature of 138 degrees Fahrenheit typically falls within the range of 29-42 mm.

Question 20

Double swap shift means that when the transmission shifts from second gear to third gear, ________.

Accepted Answer

In a double swap shift, two clutches or bands must be released to allow the transmission to shift from second gear to third gear.

Quiz 24: Chrysler 6 Speed 62te Transmission